DynaColor DH701 Installationsanleitung PDF herunterladen (Seite 14)

Installation Guide

3.1.3 ID Setting

Please change the analog Dome Camera’s ID if there is more than one Dome

Camera on the same installation site. Use the switch to change your speed

Dome Camera’s ID by turning the arrow to the desired number respectively.

For instance, if the camera’s ID is 123, the ID switch should be set as below.

NOTE: No two Dome Cameras should be given the same ID, or

communication conflict may occur.

Centesimal Digit Decimal Digit Single Digit

NOTE: The number “0” should locate upwards as shown in above

diagram for correct switch definition.

3.1.4 Camera Control Protocol Setting

Define the protocol you are going to use basing on the devices of your

surveillance system. Generally, use one protocol even the devices are

provided from different manufacturers. Use the switch to set your camera

control protocol and the baud rate. Refer to the table below and turn the

arrow to choose a protocol for your Dome Camera.

The table below shows various protocols with their matching switch numbers

and baud rate.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 64 65

Keine Kommentare

DynaColor DH701 Installationsanleitung Seite 14