DynaColor SL H.264 WD1 Bedienungsanleitung PDF herunterladen (Seite 30)

DVR User’s Manual

3.6.3 Alert Notification Setup

This function allows users to send alert notifications to the CMS software

which had been installed to users’ computer. For further setup instruction at

the CMS side, please refer to the CMS user’s manual.

Alert Notification Setup

Alert Configuration Set

Alert Notification

Alert IP

Alert Port

Alive Interval

OFF

0.0.0.0

9999

120 Sec

3.6.3.1 Alert Configuration Set

<Alert Configuration Set> provides 3 combinations of Alert Notification, IP,

Port, and Interval.

3.6.3.2 Alert Notification

4 options are included in this item: <OFF>, <Event>, <Alive>, and <Both>.

<OFF>: The Alert Notification is turned off.

<Event>: When the alarm is triggered, the DVR will send an alert message to

the CMS.

<Alive>: The DVR will send an alive message to the CMS every N second

just to show that the connection between the DVR and CMS is

active. The time interval N can be adjusted in <Alive Interval>.

<Both>: This enables the DVR to send both Event and Alive alert messages

to the CMS.

3.6.3.3 Alert IP

The Alert IP must match the IP address of the computer installed the CMS.

3.6.3.4 Alert Port

The ports for DVR and the CMS Alert MUST be the same.

3.6.3.5 Alert Interval

Users can define the time interval (1 to 255 seconds) between each alive

message. This item will not be available if <Alert Notification> is set to <OFF>

or <Event>.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 73 74

Keine Kommentare

DynaColor SL H.264 WD1 Bedienungsanleitung Seite 30